Section 5. Maintenance and Troubleshooting
PX-760 Installation and Users Manual 67
10. The drive begins the diagnostic routine. Upon completion of the
diagnostic, you see the results:
If there was no problem, the disc is ejected automatically.
If there was a problem, the disc is not ejected, and you see the
LED indicator blink green:
One green blink indicates a write or read error.
Two green blinks indicate an initialization error.
Three green blinks indicate the disc is not blank or cannot be
detected properly.
11. If the disc was not ejected automatically, press the eject button to
eject the disc.
12. Turn off the computer power.
13. Reset the mode jumper at the rear of the PX-760A to its original
setting as noted in Step 4 above. Also, remove the extra jumper you
installed.
14. Reconnect the IDE cable to the PX-760A drive. If you removed the
drive to gain access to the cable or jumpers, replace the drive in the
computer. Then replace the computer cover.
If you discover a problem with the PX-760A drive, do not attempt to
service the drive yourself. Contact us to get an RMA number and take
steps to return the drive to Plextor. See “
Returns” on page 91 for details.
To Next Page
Loading...
