PLS AR-200 - Emergency Stop; Belt Tension; Belt Switch

16
2.4.3. Emergencystop
The Ceiling Hoist has a red emergency
stop cord (Figure 8, page 16). Use this
cord in emergency situaons. When you
pull the cord shortly, the Ceiling Hoist
will stop. Connue pulling the cord to
lower the Spreader Bar slowly. This will
sll enable you in all situaons to place
the care recipient into a wheelchair, for
instance.
Release the cord to stop lowering. The
Ceiling Hoist will then be switched o fully.
Press the buon ‘CeilingHoiston’ on the Hand Control to switch the Ceiling
Hoist back on (Figure 4, page 11).
2.4.4. Belttension
This funcon prevents the hoisng belt from congesng in the Ceiling Hoist
when the belt is lowered without a load. The Ceiling Hoist is acvated by
a load equivalent to the PLS Spreader Bar, and without a load the Ceiling
Hoist is on but the motor will not work. If you want to lower the hoisng belt
without a load, you can pull gently on the belt or the Central Suspension Point
while also pressing the ‘Lowerhoisngbelt’ buon.
2.4.5. Beltswitch
Turns o the Ceiling Hoist’s motor when the hoisng belt is at its end. The
hoisng belt can now only be raised.
Figure 8, emergency stop