PLS AR-200 - Explanatory Label Overview; Connect and Release

19
This could cause constricon. Before liing, make sure that the hand control
and the cable are free of the Spreader Bar, the care recipient and any other
object. Do not allow the paent to hold the spreader bar to prevent injury
from arm or nger pinching. The operator should always hold the spreader
bar when in the vicinity of paents to avoid injury from hits from the
spreader bar. Pay special aenon when lowering to not hit the paent with
the spreader bar as this could result in an injury.
3.3. Explanatorylabeloverview
2-Point Spreader Bar example:
• 2021-01 = Year – Month.
Also, the batch number.
• 8102 = type number of
the Spreader Bar, in this case a 2-Point Spreader Bar.
• SWL = Safe Working Load in kilogram and behind this in LBS.
• WLL = Working Load Limit in kilogram and behind this in LBS.
• Manufacturer’s name and address data.
3.4. Connectandrelease
The blue dot has a marking funcon. Only when the slot is in the same line as
the dot, the hook can be connected and released on/o the Spreader Bar.
1. Hold the hook 90° to the Spreader Bar.
2. Place the opening of the hook over the pen of the Spreader Bar.
3. Pull back the hook and in the same movement, turn it back up.
4. Please, reverse these steps to release the Spreader Bar.
Spreader bars and accessories should always be installed by a trained
person. Check the connecon with Central Suspension Point before
every transfer.