PLS AR-200 - Removing Parts; If the Ceiling Hoist Is Not Working

29
7.6. Removingparts
Any parts that are replaced or removed can be returned to the
distributor. You can also give these parts to the technician for
destrucon. PLS or the distributor will ensure that these parts
are processed in an environmentally friendly manner.
If you dispose of parts yourself, the baeries must be
disposed of as chemical waste and the electronic
components must be processed according to the
WEEE guideline.
7. 7.  If t he C ei li n g  Ho ist  i s n ot wo rk in g 
Check the following if the Ceiling Hoist is not working:
• Check whether the baeries are suciently charged.
The control lighng shows the status of the baeries
(see secon 2.3). When they are empty, charge them
according to the instrucons in secon 2.2.
• Verify that the emergency stop has not been acvated.
For problem recognion and resoluon, see secon 2.4.3.
• Verify that the height limit switch has been pushed in
(see secon 2.4.2). It is sll possible to lower the Spreader Bar.
• Check whether the belt is slack and pull it ght if necessary
(see secon 2.1.1).
• Check whether the plug of the Hand Control is properly
connected. (If not; remedy this according to secon 2.1.2).
If you connue to experience problems, contact the technical department
or your distributor.