5 Maintenance
WARNING
To avoid electric shock and other hazards which
could result in permanent injury or death,
disconnect (unplug) the cleaner from the power
source before performing any cleaning and
maintenance.
Cord Tangling
Tangling can occur more frequently when the
cleaner is not attended to after each cleaning
cycle. Proper installation, general maintenance
and the following troubleshooting steps can help
to avoid cable challenges.
IMPORTANT
Cleaner power cable may become tangled if
correct procedure is not followed after each
cleaning cycle.
NOTE: Place all of the oating cable in the water to allow
free movement in your pool from the central point.
Spread out the oating cable ensuring there are no
kinks or coils in the cable (Figure 7).
caddy /
control unit
cleaner
cleaner
Recommended
entry point
Not
Recommended
WARNING: Do not use
an extension cord
Figure 7. Optimal Entry Point in Pool
If tangling occurs, follow these steps:
1. Remove the cleaner from the pool. When
the cleaner is within arm's reach, use the
handle to remove from the water. Never lift
the cleaner out of the pool by the oating
cable.
2. Hold the cleaner vertically to drain
(Figure 8).
Figure 8. Keep Cleaner Vertical to Drain Water
3. Unplug power to the cleaner at the control
box (Figure 9).
Figure 9. Unplug
10
Robotic Pool Cleaner
|
Owner's Manual
English
To Next Page
Loading...
Need help?
General
