Store the Cleaner When Not in Use
The cleaner should be cleaned regularly using
slightly soapy water. Do not use solvents such as
trichlorethylene or its equivalent. Rinse the cleaner
generously using clean water. Do not let your
cleaner dry in direct sunlight.
1. Disconnect cleaner from the power source.
2. Starting at the cleaner head, remove all
twists and tangles from the cable. Lay the
cable in the sun to loosen any tangling
memory (see Figure 14).
3. Loosely coil the cable into a loop for
storage near the cleaner or on the caddy
hook (not available with all models).
4. Disconnect the cable from the control box.
Figure 14. Untangle the power cable
Replacing Wear Parts
Replacing Brushes
The cleaner is tted with brushes with a ''wear''
indicator (Figure 15).
raised groove becomes
partially flattened,
indicating excessive
wear
Figure 15. Worn Brush Indicator
To maintain cleaner performance at its best,
replace the brushes as soon as one of the wear
indicators is reached (even if the wear is not
even). It is recommended that you replace the
brushes when the rubber is worn down to the
top of the wear indicator (or every two years,
whichever comes rst).
To replace a worn brush:
1. Stand the cleaner on its end in a vertical
position (see Figure 16).
1
Figure 16. Cleaner in Upright Position
12
Robotic Pool Cleaner
|
Owner's Manual
English
To Next Page
Loading...
Need help?
General
