3 Getting Started
Contents
The packaging should contain the following items:
• Robotic cleaner and oating cable
• Control box
• Transport and storage caddy
(not available with all models)
Connect to a Power Source
WARNING
Failure to comply with the following warnings
can result in permanent injury, electrocution or
drowning.
PREVENT ELECTRICAL SHOCK
• U.S.: Per NEC
®
requirements, keep the control
box at least ve (5) ft. (1.5 m) from the edge of the
pool. CANADA: Per CEC
requirements, keep the
control box at least three (3) m (10 ft.) from the
edge of the pool.
• Only connect the control box to a receptacle
protected by a ground fault circuit interrupter
(GFCI). Contact a certied electrician if you cannot
verify that the receptacle is protected by a GFCI.
• Do not use an extension cord to connect the
control box.
• Do not allow anyone to swim while the cleaner is
in the pool.
• The control box is water-resistant, not waterproof.
In order to prevent electrocution, never submerge
the control box or leave exposed to inclement
weather.
1. Firmly insert power cord connector (with
TOP shown facing up) until you hear a
"click" (Figure 1).
NOTE: The "click" indicates the power cord is connected
correctly.
“HAGA CLIC ”
“HAGA CLIC”
Figure 1. Connect Power Cable
NOTE: To disconnect, firmly grip the power cord connector
on each side, press the two tabs, and pull out
(Figure 2).
"CLICK"
"CLICK"
Figure 2. Disconnect Power Cable
6
Robotic Pool Cleaner
|
Owner's Manual
English
To Next Page
Loading...
Need help?
General
