SAVE THESE INSTRUCTIONS
The cleaner is a double-insulated product. A
double-insulated electrical appliance is one which
has been designed in such a way that it does not
require a safety connection to ground. The basic
requirement for double-insulation is that no single
failure can result in dangerous voltage becoming
exposed so that it might cause an electric shock
and that this is achieved without relying on an
earthed (grounded) metal casing. This is achieved
by having two (2) layers of insulating material
surrounding live parts or by using reinforced
insulation. Therefore, devices having double-
insulated construction, such as this cleaner, do not
utilize a grounded (three-prong) cord/plug.
CAUTION
Failure to comply with the following warnings could cause damage to pool equipment or personal injury.
• The cleaner must be installed and operated as specied.
• This product is intended for use with permanently-installed pools. Do not use with storable pools. A
permanently-installed pool is constructed in or on the ground or in a building such that it cannot be readily
disassembled for storage. A storable pool is constructed so that it is capable of being readily disassembled
for storage and reassembled to its original integrity.
• Clean the lter canister in the cleaner after each use.
• Do not use the product in your pool if the water temperature is above 95˚ F (35˚ C) or below 55˚ F (13˚ C).
USE OF THE ROBOTIC CLEANER IN A VINYL LINER POOL
• Certain vinyl liner patterns are particularly susceptible to rapid surface wear of pattern removal caused by
objects coming into contact with the vinyl surface, including pool brushes, pool toys, oats, fountains, chlorine
dispensers, and automatic pool cleaners. Some vinyl liner patterns can be seriously scratched or abraded
simply by rubbing the surface with a pool brush. Ink from the pattern can also rub off during the installation
process or when it comes into contact with objects in the pool. Zodiac Pool Systems LLC is not responsible
for, and the Limited Warranty does not cover, pattern removal, abrasion or markings on vinyl liners.
2 Cleaner
Technical Specications
The general specications for the cleaner are as
follows:
Control box
supply voltage
100-125 VAC, 60 Hz
Supply voltage
30 V DC
Installed load
150 W max
Specications
5
Robotic Pool Cleaner
|
Owner's Manual Robotic Pool Cleaner
|
Owner's Manual
English
To Next Page
Loading...
Need help?
General
