ELECTRICAL
10.7
To leave the diagnostic mode, either shift the machine
out of neutral or turn the key switch off and on.
NOTE: Any movement of the tires will trigger the
speedometer out of the diagnostic mode.
SPEEDOMETER REMOVAL
1. Remove the headlight pod cover and disconnect
the wire connectors from the instrument cluster.
2. Push the instrument cluster out from the backside
of the pod, while securely holding the pod.
Bezel
Instrument Cluster
Pod
Push Instrument
Cluster Outward
NOTE: Do not remove the rubber grommet in the pod.
Only remove the rubber grommet if necessary.
SPEEDOMETER INSTALLATION
1. Spray a soap and water mixture onto the outer
surface area of the instrument cluster. This will
help the instrument cluster slide into the pod
assembly more easily.
2. Be sure the rubber grommet inside the pod is fully
installed and that the indexing key is in the
headlight pod keyway.
3. Hold the pod assembly securely and insert the
instrument cluster into the pod assembly. Twist
the instrument cluster gently in a clockwise
motion to properly seat the instrument cluster into
the pod assembly. Apply pressure on the bezel
while pressing down on the instrument cluster.
NOTE: Be sure the key on the instrument cluster
housing is aligned with the keyway in the rubber
grommet, to ensure proper alignment.
NOTE: Do not allow alcohol or petroleum products to
come in contact with the instrument cluster lens.
Enfocus Software - Customer Support
To Next Page
Loading...
