ENGINE
3.8
TORQUE SPECIFICATIONS
TORQUE SPECIFICATIONS
Fastener Size 600/700
Ft. Lbs. (Nm)
Camshaft Gear 8mm 26-30 (35-41 Nm)
Camshaft Thrust Plate 6mm 4.5-5.5 (6-7 Nm)
Carburetor Adaptor 8mm 11-13 (15-18 Nm)
Counterbalance Gear 8mm 26-30 (35-41 Nm)
Crankcase 8mm 20-24 (27-33 Nm)
Crankcase Breather 5mm 27--33 in.lbs.(3--4 Nm)
Cylinder Head Bolts 12 mm 60-64 (68-73 Nm)
Exhaust Manifold 8mm 20-24 (27-33 Nm)
Flywheel 14 mm 80-100 (109-136 Nm)
Magneto Cover 6mm 8.5-9.5 (12-13 Nm)
Oil Baffle Weldment 5mm 4.5-5.5 (6-7 Nm)
Oil Drain Bolt (Crankcase) 12 mm 20--22 (27-30 Nm)
Oil Fill Tube Bolt 5mm 4.5-5.5 (6-7 Nm)
Oil Filter Pipe Fitting 20 mm 33-37 (45-50 Nm)
Oil Pick Up 5mm 4.5-5.5 (6-7 Nm)
Oil Pressure Relief Plug 10 mm 20-24 (27-33 Nm)
Oil Pressure Switch 1/4-18 8.5-9.5 (12-13 Nm)
Oil Pump Housing Screw 6mm 8.5-9.5 (12-13 Nm)
Rocker Arm 8mm 20-24 (27-33 Nm)
Rocker Cover 6mm 8.5-9.5 (12-13 Nm)
Spark Plug 14 mm 16-20 (22-27 Nm)
Starter Motor 6mm 8.5-9.5 (12-13 Nm)
Stator Assembly 6mm 9-10 (12-14 Nm)
Stator Housing 6mm 8.5-9.5 (12-13 Nm)
Temperature Switch 3/8 PT 16-20 (22-27 Nm)
Thermostat Housing 6mm 8.5-9.5 (12-13 Nm)
Timing Plug 3/4-16 7-9 (10-12 Nm)
Trigger Coil/Stator Wire Holddown 5mm 4.5-5.5 (6-7 Nm)
Water Pump Housing Cover 6mm 8.5-9.5 (12-13 Nm)
Water Pump Impeller Nut 8mm 9-11 (12-15 Nm)
Enfocus Software - Customer Support
To Next Page
Loading...
