ENGINE
3.36
Torque the bolts to 8.50--9.50 ft. lbs. (12--13 Nm).
Stator Housing Bolt Torque:
8.50-9.50 ft. lbs. (12-13 Nm)
ENGINE LOWER
DISASSEMBL
Y/INSPECTION
1. Remove the stator cover (A) and water pump
cover (B).
A
B
2. Remove the nylok nut (C), washer (D), and water
pump impeller (E). Remove part of the water
pump seal behind the impeller.
E
C
D
3. Remove flywheel nut and washer.
4. Install Flywheel Puller (PN 2871043) and remove
flywheel (F). CAUTION: Do not thread the puller
bolts into the flywheel more than 1/4² or stator
coils may be damaged.
2871043
F
5. Remove the starter bendix (G), wire holddown
plate (H), and the woodruff key (I) from the
crankshaft. The stator does not have to be
removed at this point.
G
I
H
Enfocus Software - Customer Support
To Next Page
Loading...
