ENGINE
3.14
ROCKER ARM/SHAFT INSPECTION
1. Remove breather box.
2. Remove rocker cover.
3. Mark or tag rocker arms to keep them in order for
assembly.
4. Inspect each rocker arm cam follower surface. If
there is any damage or uneven wear, replace the
rocker arm. NOTE: Always inspect camshaft lobe if
rocker arms are worn or damaged.
5. Remove cylinder block plug using a 14mm hex head
wrench.
6. Measure O.D. of rocker shaft. Inspect it for wear or
damage. Compare to specifications.
Inspect surface
of followers
Wave
washer
PTO
Cylinder block
plug
Rocker Shaft O.D.:
.8656-.8661I (21.987-22.0 mm)
To Next Page
Loading...
