110
Audio System Operation
Audio Mode Menus
To change mode settings, enter the mode menu. Press
TUNE (+) or TUNE (-) to change settings. Wait 5 sec-
onds or push VOL (+) or VOL (-) to exit.
Automatic Volume Control (AVC)
When set, this feature will lower or raise the speaker/
headset volume automatically, based on vehicle speed.
Press TUNE (+) or TUNE (-) to change settings.
Off: Volume will not adjust
Low: Least aggressive setting
Medium: Moderate setting
High: Most aggressive setting
CB Headset Volume Controls (if equipped)
The headsets have three separate volume settings: Intercom (ICOM) volume, CB receive
volume and entertainment (ENT) volume. Always position headsets with the speakers
directly over your ears to ensure the best sound quality and volume.
Tip: The driver can turn off the external speakers and listen to audio only through the headsets. See
page 109.
CB Headset ENT Mode (if equipped)
OFF: Only communications are audible in the headsets.
Riders can listen to navigation commands and
entertainment with the external speakers while reserving
the headset for communication.
MIX: The audio source volume drops lower than the
ICOM volume whenever the voice-operated switch (VOX)
is opened. The audio source volume gradually returns to its
original level after the VOX is closed.
MUTE: The audio source volume is muted when the VOX
is opened. The audio source volume gradually returns to its
original level after the VOX is closed.
Volume Adjustments
Item Can Be Adjusted Driver Controls Passenger Controls
ICOM Volume When VOX is in use
Press VOL (+) or VOL (-) Press (+) or (-) on the
headset cord control
CB Receive Volume When receiving a CB transmission
ENT Volume While listening to ENT
To Next Page
Loading...
