117
AUX / iPod
Getting Started
The ignition key must be in the ACC or ON
position to use the audio system.
Tip: To prevent battery drain, do not leave the
key in the ACC position for long periods.
VICTORY recommends using the audio sys-
tem only when the engine is running.
Press VOL (+) to turn the audio system on.
Press and release the MODE button until
AUX or iPod is active.
When AUX is active, the console screen
will display “AUX” as the active source.
When iPod is active, the console screen will
display “iPod” as the active source and iPod
information in the display screen.
To change the mode, press the MODE button
repeatedly to toggle to the AUX mode.
Press TUNE (+) or TUNE (-) to set the
mode to AUX (for iPod or any other MP3
player use) or to NAV MP3 for navigation
unit MP3 player use.
Tip: NAV MP3 mode will override any device
connected with an input cable.
iPod Song Control
Press and release TUNE (+) or TUNE (-) to
change the tracks in the currently selected
playlist.
Tip: Generic MP3 players can play music, but
cannot be controlled through the audio sys-
tem (for example, selecting tracks or playl-
ists).
Press and hold TUNE (+) or TUNE (-) to
fast-forward or fast-reverse in the currently
playing song.
A quick double press and release of TUNE
(+) or TUNE (-) will bring up a list of songs
in the currently selected playlist.
Use TUNE (+) or TUNE (-) to scroll
through this song list. The selected song
will be in reverse video on the center line of
the display. Press and release the PRE but-
ton to select and play the highlighted song,
or press and release the MODE button to
exit without selecting a new song.
To Next Page
Loading...
Need help?
General
