81
Maintenance
Saddlebag Bumpers
Saddlebag bumpers (if equipped) can be removed. Be sure to retain the M6 screws, nut
plates and spacer plates for future reinstallation.
1. Remove the saddlebags.
2. Remove the five (5) screws securing each bumper to the frame, along with the nut plate
and spacer plate.
3. Remove the bumpers. Place bumpers and hardware in a secure location for future rein-
stallation, with the exception of the three (3) M8 screws on each side.
4. Reinstall the M8 screws for mufflers and
saddlebag bracket.
Torque: 18 ft-lbs (24.4 Nm)
5. Reinstall the saddlebags.
6. To reinstall the saddlebag bumpers, reverse
the removal instructions, using the hardware
removed with the bumpers. Tighten the
bumper screws to the following specifica-
tions:
Torque: 84 in-lbs (9.4 Nm) for M6 fasteners
Torque: 18 ft-lbs (24.4 Nm) for M8 fasteners
Nut
Plate
Spacer
Plate
M6
Screws
M8
Screws
M8
Screw
Step 4
To Next Page
Loading...
Need help?
General
