20
Instruments, Features and Controls
Instrument Cluster (CROSS ROADS)
Speedometer
The speedometer displays vehicle speed in either
miles per hour (MPH) or kilometers per hour (km/h).
Indicator Lamps
Lamp Indicates Condition
Neutral This lamp illuminates when the transmission is in neutral and the ignition
key is in the ON position.
High Beam This lamp illuminates when the headlamp switch is set to high beam.
Turn Signal The turn signal indicator flashes when the left, right, or both turn signals
(hazard) are active. If a bulb fails, or if there is a short circuit in the signal
system, the lamp flashes at more than twice the normal rate.
Low Fuel This lamp illuminates when approximately one gallon (3.8 liters) of fuel
remains in the fuel tank.
Cruise Control
Engaged
Before using the cruise control (if equipped), read the safety and
operation procedures beginning on page 49.
Check Engine This lamp illuminates momentarily when the ignition switch is in the ON
position and the engine is off. This indicates proper function. If this lamp
illuminates while the engine is running, contact an authorized VICTORY
dealer promptly for diagnosis. The light will remain on if the tilt sensor
shuts down the engine. See page 34. If abnormal sensor or engine
operation is detected the light will remain on as long as the fault
condition exists. Retrieve the error codes for diagnosis. See page 26.
Anti-Lock Brake
System Not
Activated
(if equipped)
The ABS indicator always illuminates when the key is in the ON position
and remains on until the anti-lock system activates, which occurs when
vehicle speed exceeds 6 MPH (10 km/h). When the lamp is illuminated,
the anti-lock brakes will not activate, but the conventional brake system
will continue to operate normally.
To Next Page
Loading...
Need help?
General
