50
Operation
Using Cruise Control (if equipped)
Resume Speed
After disengaging the cruise control with the brake, throttle
or clutch, wait at least 3 seconds, then press the resume but-
ton (RES) to return to the set speed.
If the resume button is pressed within 3 seconds of disengag-
ing, the cruise control may not engage, even if the cruise con-
trol indicator illuminates. This is a safety feature that
prevents cruise control from engaging if a button is stuck. To
continue using cruise control, disengage it. Wait at least 3
seconds, then press the resume button.
Tip: Turning the cruise control master switch off will erase the set
speed from memory and disengage the cruise control.
Accelerate
Tap and release the accelerate (ACC) button to increase speed in approximately 1 MPH (1-2
km/h) increments. Press and hold the ACC button to accelerate to a new SET speed (resets
when button is released).
Tip: If you use the throttle to accelerate and then release it, the cruise control will resume the previ-
ously set speed.
Decelerate
Tap and release the decelerate (DEC) button to decrease
speed in approximately 1 MPH (1-2 km/h) increments.
Press and hold the DEC button to decelerate to a new SET
speed (resets when button is released), or to the minimum
cruise speed of 25 MPH (40 km/h).
Cancel Cruise Control
To temporarily cancel the cruise control and allow use of the
resume feature:
• apply the brakes
• or close the throttle
• or disengage the clutch
To cancel the cruise control and erase the set speed from memory, press OFF.
To Next Page
Loading...
Need help?
General
