Use 2x AAA (1.5V) batteries. Alkaline batteries are recommended. Batteries not included.
1) Open the battery/memory card compartment door.
2) Insert the batteries properly into your digital camera, according to the polarity shown inside
the battery compartment.
3) Securely close the battery/memory card compartment door.
NOTE:
Remove the batteries from the camera when not in use for an extended period.
Do not mix alkaline and non-alkaline batteries.
Some features, such as Flash, will not work if the battery power level is low.
When the battery power is low the battery icon turns red and the camera will automatically
turn off a few seconds later.
The energy status of the power is displayed on LCD as shown below:
Full battery power Medium battery power
Low battery power Battery empty
To Next Page
Loading...
