Configure Deployment Mode
You can manually configure the deployment mode from the system user interface.
You can't configure the deployment mode when the G200 system is in a call, sharing content, or
upgrading the camera.
Procedure
1. In the system web interface, go to System Settings > Deployment Mode.
2. Choose the mode from the drop-down list and select Submit.
Note: The system automatically reboots to apply the change.
Configure H.323 Settings
If your network uses a gatekeeper, the G200 system can register its H.323 name and extension. This
enables others to call the system by entering the H.323 name or extension instead of the IP address.
The following settings are only available for AVC mode.
Procedure
1. In the system web interface, go to Server Settings > Call Server.
2. Configure the following settings and select Submit.
Setting Description
Communication
Protocol
Specifies the registrar protocol. Select H.323.
Enable H.323
Registration
Enables you to display and configure the H.323 settings.
Gatekeeper Address Gatekeeper address that the network is using.
H.323 Name Specifies the name that gatekeepers and gateways use to identify this system.
You can make point-to-point calls using H.323 names if both systems are
registered to a gatekeeper.
H.323 Extension (E.
164) (My Number)
Enables users to place point-to-point calls using the extension if both systems
are registered with a gatekeeper, and specifies the extension that gatekeepers
and gateways use to identify this system.
Your organization's dial plan might define the extensions you can use.
Require Authentication Enables support for H.235 Authentication.
When H.235 Authentication is enabled, the H.323 gatekeeper ensures that
only trusted H.323 endpoints are allowed to access the gatekeeper.
This setting is available when Enable H.323 Registration is set to Enable.
Privacy-Related Options
6
To Next Page
Loading...
Need help?
General
