Setting Description
SIP Address (My
Number)
Specifies the SIP address or SIP name of the system, for example,
mary.smith@department.company.com. If you leave this field blank,
the system’s IP address is used for authentication.
User Name Specifies the user name to use for authentication when registering with a SIP
proxy server, for example, marySmith. If the SIP proxy server requires
authentication, this field and the password cannot be blank.
Password Specifies the password associated with the user name used to authenticate
the system to the proxy server. The password can be up to 47 characters in
length.
Related Links
Right to Access on page 11
Call Detail Report (CDR) on page 3
Configure SVC Call Settings
If you use SVC mode, use the Poly RealPreasence Clariti Ensemble server as the call server.
Make sure to enable SVC deployment mode.
Important: Poly RealPreasence Clariti Ensemble 1.0 only supports English device names.
Procedure
1. In the system web interface, go to Server Settings > Call Server.
2. Configure the following settings and select Submit.
Setting Description
Device Name Specifies the name of your G200 system registered to the RealPreasence
Clariti Ensemble server.
Note: To avoid duplicate device names, you must change the default device
name.
Server Address Specifies the RealPresence Clariti Ensemble server you want to use.
Note: If the RealPresence Clariti Ensemble server doesn't use the default
FQDN/IP port 443, you need to specify the port in the server address
as <ip>:<port>. For example: 10.11.12.13:446.
User Name Specifies the user name that registers the system to the RealPresence Clariti
Ensemble server.
Password Specifies the password that registers the system to the RealPresence Clariti
Ensemble server.
Privacy-Related Options
8
To Next Page
Loading...
Need help?
General
