Poly TC10 - Joining Meetings from the Calendar

Using the Poly TC10 in Poly Video Mode
Pair the Poly TC10 with a video system and set the Provider to Poly in the system web interface to control and manage
your Poly video system with the Poly TC10.
Note: Poly Video Mode isn't available if the Poly TC10 is in standalone mode.
Related Links
Poly TC10 in Poly Video Mode as a Room Controller on page 5
Cameras
Camera controls are available in and out of calls.
You can control cameras, depending upon the camera type, in the following ways:
• Adjust an in-room camera
• Turn camera tracking on or off
Selecting the Primary Camera
In Poly Video Mode and Zoom Rooms, if you have more than one camera attached to the system, you can select the
primary camera in or out of a call.
Camera Priority
When you connect or disconnect a camera, camera priority determines the primary or active camera.
Note: The system doesn't support hot plugging cameras while in Device Mode. If the system is in Device Mode, exit
Device Mode before attaching a camera to the system.
• When you attach a camera to a system that’s powered on, it automatically becomes the current people camera.
• If you attach a camera during a call, it automatically becomes the current people camera.
• If you disconnect the current people camera, the system falls back to the next priority camera.
The system observes the following camera type priority:
1 Embedded camera
2 HDCI camera
3 USB camera
4 HDMI source set to display as people
Select the Primary Camera Using the Poly TC10
When you attach multiple cameras to the system, you can select the primary camera from the TC10 Camera Controls
screen.
Task
1 Select Camera .
2 From the camera drop-down menu, select a camera.
The selected camera becomes the primary camera.
Using Camera Presets
If your camera supports presets, you can save up to 10 camera positions. Camera presets are stored camera positions that
let you quickly point a camera at predefined locations in a room.
Near camera presets are available in or out of a call. Far camera presets are only available during a call. If enabled, you can
use them to control the far-site camera.
When you save a preset, the preset saves the selected camera and the camera position.
16