Polycom 1725-11530-310 - Call Handling Configuration <Call

Administrator’s Guide SoundPoint IP / SoundStation IP
A - 64
This attribute also includes:
Configuration <cfg/>
Configuration <cfg/>
This configuration attribute is defined as follows:
Call Handling Configuration <call/>
This configuration attribute is defined as follows:
Attribute
Permitted
Values
Default Interpretation
httpd.cfg.enabled 0, 1 1 If set to 1, the HTTP server configuration interface
will be enabled.
httpd.cfg.port 1-65535 80 Port is 80 for HTTP servers. Care should be taken
when choosing an alternate port.
Attribute
Permitted
Values Default Interpretation
call.rejectBusyOnDnd 0, 1 1 If set to 1, reject all incoming calls with the
reason “busy” if do-not-disturb is enabled.
Note: This attribute is ignored when the line is
configured as shared. The reason being that
even though one party has turned on DND, the
other person/people sharing that line do not
necessarily want all calls to that number diverted
away.
Note: If server-based DND is enabled, this
parameter is disabled.
call.enableOnNotRegistered 0, 1 1 If set to 1, calls will be allowed when the phone is
not successfully registered, otherwise, calls will
not be permitted without a valid registration.
call.offeringTimeOut positive
integer
60 Time in seconds to allow an incoming call to ring
before dropping the call, 0=infinite.
Note: The call diversion, no answer feature will
take precedence over this feature if enabled. For
more information, refer to No Answer
<noanswer/> on page A-115.
call.ringBackTimeOut positive
integer
60 Time in seconds to allow an outgoing call to
remain in the ringback state before dropping the
call, 0=infinite.