17 Polycom CX5000 Setup Guide
2. Plug both RJ11 connectors attached to the satellite microphones into the RJ11
jacks at the bottom of the device.
3. Run the RJ11 cables through the conduit so that the cords are securely lodged
and sit below the surface of the Polycom CX5000 base bottom.
4. Place the Polycom CX5000 device upright on the table and check to see that
the RJ11 cords do not disrupt the stability of the device. If so, return to the
previous step and make certain the RJ11 cables are lodged securely into the
conduit.
To Next Page
Loading...
