Polycom G7500 - Page 45

device.net.mode
Specifies how you want to configure your system IPv4 address on the wired LAN.
If set to "Automatically", make sure you have a DHCP server in your environment.
Automatically (default)
Manually
device.wifi.enable
Enables or disables Wi-Fi wireless comminication on your system.
Setting to "0" turns off screen mirroring with Miracast-certified devices and prevents the system
from using Wi-Fi to connect to a secondary network.
1 (default)
0
device.net.secondaryNetwork.type
Specifies if you want your system to connect to a secondary network over Wi-Fi for additional
access (e.g., guest users).
None (default)
WiFi
device.net.secondaryNetwork.wifi.ssid
Specifies the Wi-Fi network name.
String (0-32)
device.net.secondaryNetwork.wifi.securityType
Specifies the Wi-Fi network encryption protocol.
WPA_PSK (default)
None
WEP
802_1xEAP
device.net.secondaryNetwork.wifi.WEP.key
Specifies the WEP key.
You should set this if device.net.secondaryNetwork.wifi.securityType="WEP".
1 (default)
0
device.net.secondaryNetwork.wifi.dot1xEAP.method
Specifies the extensible authentication protocol (EAP) for WPA-Enterprise (802.1xEAP).
You should set this if device.net.secondaryNetwork.wifi.securityType="802_1xEAP".
PEAP (default)
TLS
TTLS
PWD
device.net.secondaryNetwork.wifi.dot1xEAP.phase2Auth
Network Parameters
Polycom, Inc. 43