If enabled, you don't have to set device.net.ethernet.portSpeed or
device.net.ethernet.duplexMode.
1 (default)
0
device.net.ethernet.duplexMode
Specifies the duplex mode to use. Note that the speed you choose must be supported by the
switch.
You don't need to set this if device.net.ethernet.autoNegotiation="1".
Half (default)
Full
device.net.ethernet.portSpeed
Specifies the wired LAN speed to use. Note that the speed you choose must be supported by
the switch.
You don't need to set this if device.net.ethernet.autoNegotiation="1".
10Mbps
100Mbps (default)
1000Mbps
device.net.hostName
Indicates your system name. If the system discovers a valid name during setup or a software
installation, the host name is automatically created. However, if an invalid system name is
found, such as a name with a space, the system creates a host name using the following format:
SystemType-xxxxxx, where xxxxxx is a set of random alphanumeric characters.
IPv4 networks: The system sends the host name to the DHCP server to attempt to register the
name with the local DNS server or look up the domain where the system is registered (if
supported).
String (0-36)
roomseries
device.net.icmp.txRateLimit
Specifies the minimum number of milliseconds between transmitted packets.
The default value of 1000 means the system sends 1 packet per second. If you enter 0, the
transmission rate limit is disabled.
This setting applies only to "error" ICMP packets. This setting has no effect on "informational"
ICMP packets, such as echo requests and replies.
Integer (0-60000)
1000
device.net.ignoreRedirect
Enables the system to ignore ICMP redirect messages.
Polycom recommends you enable this setting in most circumstances.
1 (default)
0
Network Parameters
Polycom, Inc. 46
To Next Page
Loading...
Need help?
General
