Polycom G7500 - Page 49

device.net.lldp.enable
Specifies if you want the system to advertise itself on the network using the Link Layer
Discovery Protocol (LLDP).
Set to "1" if you want your system to operate on a virtual LAN (VLAN).
If set to "1", system.network.wired.vlan.enabled and system.network.wired.vlan.vlanid should be
automatically configured.
0 (default)
1
device.net.unreachableTx.enable
Generates an ICMP Destination Unreachable message if a packet cannot be delivered to its
destination for reasons other than network congestion.
1 (default)
0
device.net.vlan.audioPriority
Sets the link layer priority of audio traffic on the wired LAN. Audio traffic is RTP traffic consisting
of audio data and associated RTCP traffic.
Setting "6" or "7" isn't recommended.
To use this parameter, you should set device.net.lldp.enable="1".
0 (default)
1
2
3
4
5
6
7
device.net.vlan.controlPriority
Sets the link layer priority of control traffic on the wired LAN. Control traffic is consists of control
information associated with a call:
H.323: H.225.0 Call Signaling, H.225.0 RAS, H.245, Far-End Camera Control (FECC)
SIP: SIP Signaling, FECC, Binary Floor Control Protocol (BFCP)
Setting "6" or "7" isn't recommended.
To use this parameter, you should set device.net.lldp.enable="1".
0 (default)
1
2
3
4
5
Network Parameters
Polycom, Inc. 47