Polycom G7500 - Page 69

0 (default)
1
sec.TLS.customCaCert.1
Specifies a CA-signed PKI certificate to install on your system.
Your system accepts the following certificate file formats: .pem, .der, and PKCS #7 (which
typically has a .p7b filename extension).
String
sec.TLS.customCaCert.2
Specifies a CA-signed PKI certificate to install on your system.
Your system accepts the following certificate file formats: .pem, .der, and PKCS #7 (which
typically has a .p7b filename extension).
String
sec.TLS.customCaCert.3
Specifies a CA-signed PKI certificate to install on your system.
Your system accepts the following certificate file formats: .pem, .der, and PKCS #7 (which
typically has a .p7b filename extension).
String
sec.TLS.revocation.crl.1
Specifies a CRL to install on your system for certificate revocation checks.
Installing a CRL will fail unless you've installed all of the certificates in the issuing CA's chain of
trust for that CRL.
To use this parameter, make sure to set sec.TLS.revocation.ocsp.enable="0".
String
sec.TLS.revocation.crl.2
Specifies a CRL to install on your system for certificate revocation checks.
Installing a CRL will fail unless you've installed all of the certificates in the issuing CA's chain of
trust for that CRL.
To use this parameter, make sure to set sec.TLS.revocation.ocsp.enable="0".
String
sec.TLS.revocation.crl.3
Specifies a CRL to install on your system for certificate revocation checks.
Installing a CRL will fail unless you've installed all of the certificates in the issuing CA's chain of
trust for that CRL.
To use this parameter, make sure to set sec.TLS.revocation.ocsp.enable="0".
String
sec.TLS.revocation.looseRevocation.enable
CRL method: When you enable this parameter, a certificate in the chain of trust validates
without a revocation check if no corresponding CRL from the issuing CA is installed.
Security Parameters
Polycom, Inc. 67