Polycom G7500 - Page 85

Polycom does not support SNMP write operations for configuring or provisioning systems. The
community string is for read operations and outgoing SNMP traps.
String (0-256)
public (default)
Note: For security reasons, do not use the default community string.
snmp.contactName
Specifies the name of the person responsible for remotely managing the system.
String (0-64)
IT Administrator (default)
snmp.locationName
Specifies the system location.
String (0-256)
snmp.systemDesc
Provides details about what kind of system it is.
String (0-256)
Videoconferencing Device (default)
snmp.auth.userId
Specifies the User Security Model (USM) account name for SNMPv3 message transactions.
You must set snmp.version3.enable="1" to configure this parameter.
String (0-64)
snmp.auth.algorithm
Specifies the type of SNMPv3 authentication algorithm used.
You must set snmp.version3.enable="1" to configure this parameter.
SHA (default)
MD5
snmp.auth.password
Specifies the SNMPv3 authentication password.
You must set snmp.version3.enable="1" to configure this parameter.
String (0-48)
snmp.privacyAlgorithm
Specifies the cryptographic privacy algorithm for SNMPv3 packets.
You must set snmp.version3.enable="1" to configure this parameter.
CFB-AES128 (default)
CBC-DES
snmp.privacyPassword
Specifies the SNMPv3 privacy (encryption) password.
SNMP Parameters
Polycom, Inc. 83