Polycom HDX 8000 - Polycom HDX Quick Reference Guide

Polycom HDX
Quick Reference Guide
1
Plug the power cable into the power
outlet in the wall.
Plug the network cable into the
network outlet in the wall. The network
cable must be plugged into the OTN-
dedicated network outlet.
2
Verify that the Power Bar is turned
On – The power supplies the whole
system – you can turn off your system
here at the end of your session.
3
4
Verify that the monitor is on
Verify that the codec/camera is on
by checking the switch on the front of
the tower or by pressing the power
button at the top of the remote control.
5
Place call to patient/virtual site.
Press the Directory button on the
remote – select entry from the Global
directory and highlight the desired
location
Press the Call button to connect to site.
6
7
Pick up the remote control.
Unmute your videoconferencing sound
by pressing the orange “Mute” button
located in the center of the remote
control.
OTN SERVICE DESK 1-866-454-6861
Reminder – provide site name/number when contacting service desk:
14