Polycom Pano - Getting Started with Polycom Pano App

Setting Description
Time Format Specifies how the time displays in the
interface.
Auto Adjust for Daylight Saving Time Specifies the daylight saving time setting.
When you enable this setting, the system
clock automatically changes for daylight
saving time.
Time Zone Specifies the time difference between GMT
and your location.
Time Server Specifies whether the connection to a time
server is automatic or manual for system time
settings. You can also select Off to manually
enter the date and time.
Primary Time Server Address Specifies the address of the primary time
server to use when Time Server is set to
Manual.
Secondary Time Server Address Specifies the address of the time server to use
when the Primary Time Server Address
does not respond. This is an optional field.
Current Date and Current Time If Time Server is set to Manual or Auto, the
system doesn’t display these settings.
If Time Server is set to Off, Current Date and
Current Time are configurable.
Set Device and Room Names
You can set the device and room names associated with a standalone Pano system using the system
web interface.
You must use the Polycom Cloud Service Administration portal to change the names of a system that is
registered with the Polycom Cloud Service.
Procedure
1. In the system web interface, go to General Settings > Device and Room Name.
2. Enter the Device Name or Room Name and select Save.
Register with Polycom Cloud Service
You can register your system to the Polycom Cloud Service through the setup wizard or in the system
web interface.
Besides the first step, the following instructions are the same whether you chose to register during initial
setup or later in the system web interface.
General Settings
Polycom, Inc. 18