2. In the system web interface, go to General Settings > Pairing.
3. Select Start Content for one or both of the following tests depending on your setup:
▪ Test Content to RealPresence Group Series: Checks if the Pano system HDMI Output
port is properly connected to the Polycom video system HDMI Input port. You can tell the
test is successful without simulating a call if the Polycom video system enters a preview
state.
▪ Test Content to Pano: Checks if the Polycom video system Monitor 2 port is properly
connected to the Pano system HDMI Input port. You can tell the test is successful without
simulating a call if the Pano system screen displays content from the Polycom video system.
If unsuccessful, an error message displays on the Pano system web interface indicating that
no content is detected.
4. When a test completes without errors, select Stop Content.
Related Links
Complete the Two-Monitor Setup (HDMI Splitter or HDMI USB Adapter) on page 69
Complete the Three-Monitor Setup on page 72
Complete the Two-Monitor Setup (Direct Connection) on page 64
Unpair a Polycom Video System
You can unpair a Polycom video system from a Pano system when you no longer want to pair with it,
such as to pair a different system.
Procedure
1. Open a browser and enter the system IP address using the format https://10.11.12.13.
2. In the system web interface, go to General Settings > Pairing.
3. Select Unpair.
Integrating with a Polycom Video System
Polycom, Inc. 75
To Next Page
Loading...
