Network Settings
Topics:
▪ LAN Status Lights
▪ Configure IP Address Settings
▪ Configure DNS Settings
▪ Configure LAN Options
Once you have connected the Pano device to the LAN, you can begin configuring its network settings.
Note: Not all network types are available in every country.
Related Links
Access the System Web Interface on page 9
LAN Status Lights
The LAN connector on the Pano device has two lights to indicate connection status and traffic.
Indicator Light Connection Status
Both lights off No 10/100/1000 Base-T connection and no network
traffic
Green and yellow lights on 10/100/1000 Base-T connection
Green light on and blinking yellow light 10/100/1000 Base-T connection with network traffic
Configure IP Address Settings
You can configure IPv4 and IPv6 settings for the Pano system.
Procedure
1. In the system web interface, go to Network > IP Addresses.
2. Select one of the following options to specify how the Pano system gets its IP address:
▪ Obtain IP address automatically
▪ Enter IP address manually
3. Configure the following IPv4 settings as needed:
Polycom, Inc. 23
To Next Page
Loading...
