Procedure
1. In the system web interface, go to General Settings > Provisioning Server.
2. Select the Enable Provisioning setting.
Configure a Provisioning Service
After enabling the service, you must register your Pano system for provisioning.
Procedure
1. In the system web interface, go to General Settings > Provisioning Server.
2. Select Load Discovered Information.
The registration fields complete automatically if your Pano system detects a provisioning server.
3. If your system did not detect a provisioning server, complete the following fields with information
from your network administrator:
Setting Description
Server Type Specifies the type of provisioning server (e.g., RealPresence Resource
Manager).
Server Address Address of the system running the provisioning service.
Domain Name Domain for registering with the provisioning service.
Username Username for registering with the provisioning service.
Password Password for registering with the provisioning service.
4. Select Save to register with the provisioning service.
5. Verify that Registration Status changes from Pending to Registered.
It might take a minute or two for the status to change.
Disable a Provisioning Service
You can disable a provisioning service on the Pano system web interface.
Procedure
1. In the system web interface, go to General Settings > Provisioning Server.
2. Disable the Enable Provisioning setting.
Provisioning Service
Polycom, Inc. 22
To Next Page
Loading...
