Setting Description
If the system does not automatically obtain a
gateway IP address, enter one here.
This setting is configurable only when you
select Enter IP address manually.
5. Select Save.
Configure DNS Settings
You can configure the DNS settings for the Pano system.
Procedure
1. In the system web interface, go to Network > DNS.
2. If the system does not automatically obtain a DNS server address, enter one on this page (up to
four are allowed).
3. Select Save.
Configure LAN Options
There are several options for configuring the LAN in your Pano system web interface.
Procedure
1. In the system web interface, go to Network > LAN Options.
2. Configure the following settings as needed:
Setting Description
Host Name Indicates the system name
Domain Name The domain name assigned to the system.
If the system does not automatically obtain a
domain name, enter one here.
Autonegotiation Specifies whether the system should
automatically negotiate the LAN Speed and
Duplex Mode per IEEE 802.3 autonegotiation
procedures. If enabled, those settings become
read-only.
Polycom recommends that you use
autonegotiation to avoid network issues.
LAN Speed Specifies whether to use 10 Mbps, 100 Mbps,
or 1000 Mbps for the LAN speed. The duplex
Network Settings
Polycom, Inc. 25
To Next Page
Loading...
