Polycom Pano - Troubleshooting; View System Information; Locate the System Serial Number; Locating the IP Address

Setting Description
mode you choose must be supported by the
switch.
Duplex Mode Specifies the duplex mode to use. The duplex
mode you choose must be supported by the
switch.
Ignore Redirection Messages Enables the system to ignore ICMP redirect
messages.
ICMP Transmission Rate Limit (millisec) Enter a number between 0 and 1000 to
specify the minimum number of milliseconds
between transmitted packets. The default
value of 1000 signifies that the system sends
1 packet per second. If you enter 0, the
transmission rate limit is disabled.
This setting applies only to “error” ICMP
packets and has no effect on “informational”
ICMP packets, such as echo requests and
replies.
Enable EAP/802.1X Specifies whether 802.1X authentication is
enabled. The following authentication
protocols are supported:
▪ EAP-MD5
▪ EAP-PEAPv0 (MSCHAPv2)
▪ EAP-TTLS
▪ EAP-TLS
EAP/802.1X Identity Specifies the system's identity for 802.1X
authentication. This setting is available only
when EAP/802.1X is enabled. The field
cannot be blank.
EAP/802.1X Password Specifies the system's password for 802.1X
authentication. This setting is required when
EAP-MD5, EAP-PEAPv0, and EAP-TTLS are
used.
Network Settings
Polycom, Inc. 26