Polycom VSX Series

Integrator's Reference Manual for the VSX Series
3 - 28 www.polycom.com/videodocumentation
ipdialspeed ipdialspeed <set|get><“valid
speed”><on|off>
Where:
• set: Sets the IP dialing speed. The
parameters “valid speed” and on or
off are required.
•get: Returns the current setting (on
or off). The parameter “valid speed”
is required.
• “valid speed”: Valid speeds are:
56, 64, 2x56, 112, 2x64, 128, 168,
192, 224, 256, 280, 320, 33 6, 384,
392, 7x64, 8x56, 504, 512, 560, 576,
616, 640, 672, 704, 728, 768, 784,
832, 840, 16x56, 14x64, 952, 960,
1008, 1024, 1064, 1088, 1120,
1152, 1176, 1216, 1232, 1280,
1288, 24x56, 21x64, 1400, 1408,
1456, 1472, 1512, 1536, 1568,
1600, 1624, 1664, 1680, 1728,
1736, 32x56, 28x64, 1848, 1856,
1904, and 1920 kbps.
•on: Enables the specified speed.
•off: Disables the specified speed.
Sets or gets the valid IP dialing
speed, and enables or disables
the specified speed.
User interface screen location:
System > Admin Settings >
Network > Call Preference
(page 3): Preferred Speeds
ipdialspeed get
168
returns:
ipdialspeed 168
off
ipisdninfo ipisdninfo
<both|ip-only|isdn-only|none|get>
Where:
•both: Displays IP and ISDN
information on the Home screen.
•ip-only: Displays only IP information
on the Home screen.
•isdn-only: Displays only ISDN
information on the Home screen.
•none: Does not display any IP or
ISDN information on the Home
screen.
• get: Returns the current setting
(both, ip-only, or isdn-only, or none).
Determines whether the home
screen displays IP information,
ISDN information, both, or
neither.
User interface screen location:
System > Admin Settings >
General Settings > Home
Screen Settings (page 2): IP or
ISDN Information
ipisdninfo
ip-only
isdnarea-
code
isdnareacode <set|get> ["area
code"]
Where:
• set: Sets the ISDN area code when
followed by the “area code”
parameter. To erase the current
setting, omit “area code”.
•get: Returns the area code
information.
• “area code”: Numeric value.
Sets or gets the ISDN area code
or STD code associated with the
area where the system is used.
User interface screen location:
System > Admin Settings >
Network > ISDN: Area Code
Note: This screen is only acces-
sible if you have a Quad BRI
network interface connected to
your system.
isdnareacode set
512
Command Syntax Description Example