Polycom VSX Series

Chapter 3 - System Commands
© Polycom, Inc. 3 - 37
telecountry-
code
telecountrycode <set|get>
["telephone country code"]
Where:
• set: Sets the telephone country
code when followed by the
“telephone country code”
parameter. To erase the current
setting, omit the parameter.
• get: Returns the country code
information.
• “telephone country code”:
Numeric value. This code is the
same as the ISDN country code.
Sets or gets the system’s
telephone country code. This
code is associated with the
country where the system is
used. The system is generally
able to automatically determine
the country code based on the
country you selected during
initial system setup.
User interface screen location:
System > Admin Settings >
General Settings > Location:
Country Code
Note: This option is automati-
cally set by the Country.
telecountrycode
set 33
telenumber telenumber <set|get> ["telephone
number"]
Where:
• set: Sets the telephone number
when followed by the “telephone
number” parameter. To erase the
current setting, omit the parameter.
• get: Returns the current setting.
• “telephone number”: System’s
telephone number. Enclose the
string in quotation marks if it
includes spaces. Example: “512 555
1212”
Sets or gets the system’s
telephone number.
User interface screen location:
System > Admin Settings >
Network > Telephony: Room
Telephone Number
telenumber set
5551212
validateac-
ctnum
validateacctnum <yes|no|get>
Where:
• yes: Enables the GMS account
number validation option.
•no: Disables the GMS account
number validation option.
• get: Returns the current setting (yes
or no).
Sets the validation for the GMS
account number that is used
when dialing out. When the call
connects, the VSX system
verifies that the account exists
with the Global Management
System (GMS) server. If the
account does not exist, the call
is disconnected.
User interface screen location:
System > Admin Settings >
Global Services > Account
Validation: Validate Account
Number
Note: This option is only avail-
able if the Required Account
Number to Dial is enabled.
validateacctnum
yes
Command Syntax Description Example