Quickstart Guide | Polycom VVX 1500 Series Quickstart Guide | Polycom VVX 1500 Series7 4
Conference Calls
Setting up Conference Calls
You can set up a conference call with two other people. During
a conference call, you can send and receive video with only one
conference participant. If you want, you can switch the person
with whom you exchange video.
To set up a conference:
• Call the first party
• After the first party answers, tap the Conference
soft key. The active call is placed on hold
• Place a call to the second party.
• When the second party answers, tap the
Conference soft key. All parties are joined in the
conference.
You can do the following:
• To place the conference on hold, tap the Hold soft
key. To resume the call, tap the Resume soft key.
• To end the conference, but keep the other participants
connected, tap the End Call soft key
• To end the conference and place all participants on
hold, tap the Split soft key
• To start and stop the transmission of near-site video,
tap the Video soft key, and then tap the Stop Video
soft key. (You will still receive video.) To start the
transmission of near-site video again, tap the Start
Video soft key.
Using Video
Make sure you open the privacy shutter (centred above the
touch screen) using the privacy shutter adjuster (centred along
the top edge, above the camera). You can also adjust the camera
barrel (located behind the camera) up or down.
During a video call, tap the Video soft key to do the following:
• To start or stop transmitting video, tap the Start
Video or Stop Video soft key.
• To display the video that appears in the large
window on the entire screen, tap the Full Screen
soft key. To return to normal viewing mode, tap the
full screen video.
• To toggle the video to display large far-site video
with PIP near-site video, or PIP far-site video with
larger near-site video, tap the Swap soft key.
• To exit the video options, tap the Back soft key.
To Next Page
Loading...
