Polyprint S.A. Texjet+
Polyprint S.A ā Texjet plus operation manual English V1.9
Scale CR:
The Scale CR is a thin film which contains the encoding information for the Printhead
movement. This part might get dirty from dust or excess of ink during printing.
To clean it, use a lint free paper and isopropyl alcohol. Repeat it until no dirt or ink comes out of
it on the paper.
Printhead surface:
The dried out ink on the Printhead surface bellow has to be removed for proper operation.
This part gets dirty during printing and after long printing operation from excess of ink.
To clean it you must use a swab or lint free paper with cleaner. If necessary move the tray back
to have easier access on the Printhead surface bellow. Clean only the area around the Printhead
as shown in the picture bellow. The shinny area that mirrors should not been touched or
scratched.
To Next Page
Loading...
