How to Reset the Wi-Fi Module
Resetting the Wi-Fi module will clear any saved Wi-Fi connection information and set the
Wi-Fi module into “Hot Spot” mode ready for running the Setup Wizard in the Pool Lab
mobile apps.
The Wi-Fi module will remain in “Hot Spot” mode for up to 2 hours, or until the Setup
Wizard is complete. During this time the Wi-Fi module will appear as a Wi-Fi access point
with the SSID “poolLab”, and password “123456789”.
If you do not complete the Setup Wizard within 2 hours window, the Wi-Fi module will turn
OFF. To re-enter “Hot Spot” mode you can either reset the Wi-Fi module again, or simply
cycle power OFF and back ON to the Pool Lab Chlorinator.
Once the Setup Wizard has been completed the Wi-Fi connection information will be
saved to the memory of the Wi-Fi module, allowing it to connect automatically to your
selected Wi-Fi network as required. The saved information will persist through power
outages and Wi-Fi network interruptions, etc.
If your Wi-Fi network password or SSID changes, then you will need to reset the Wi-Fi
module and complete the Setup Wizard again.
– From the HOME view, press and hold the VIEW button until the MAIN MENU
appears.
– Navigate to SYSTEM CONFIG and press the VIEW button.
– Navigate to AUTHORITY and press the VIEW button.
– Press the VIEW button once more to edit the AUTHORITY level (flashing), and
press UP once to set this to “INST”. Press VIEW again to save the value.
– Press BACK once to return to the SYSTEM CONFIG menu.
– Navigate down to RESET WIFI and press the VIEW button.
(Note: this option will only appear if AUTHORITY is set to INST or higher)
– Press VIEW to reset the Wi-Fi module, or press BACK to cancel.
14
To Next Page
Loading...
