ADD-ON MODULES
ASP
The Pool Lab ASP or Auto Sampling Photometer is the World's most reliable and accurate
water management system. The ASP will periodically test your water for Free Chlorine
and pH levels and adjust the chlorinator output and feed acid as required. Developed and
Patented by Poolpower Australia Pty Ltd, the ASP does not suffer from the limitations of
ORP probe based systems and the accuracy is not affected by stabiliser levels, hydrogen
gas or changes in pH. The ASP does not require cleaning or calibration and is suitable for
use on both pools and spas, as well as combination pool and spa systems. Reagent sets
require replacement after approximately 700 tests, or 6 – 8 months at 3 tests per day.
EXP
The Pool Lab EXP or Expansion Module allows you to control of all of your pool and spa
equipment from your Pool Lab Salt Chlorinator and for Pool Lab MAX models, from the
convenience of your mobile device or smart speaker. The system features:
– Fully integrated solar heating control. Compatible with isolated solar systems,
multi-pump split solar systems, retro-fit or boost pump systems, as well as valve
controlled solar on single pump systems.
– Fully integrated gas heating control, which is also compatible with heat pumps that
have the option for external control.
– Control of up to 4 flow control valve actuators for pool and spa combination
systems, solar systems, water features, in-floor cleaning systems, etc.
– Control up to 9 x 240V outlet sockets for equipment such as lighting, pumps,
cleaners, or any other plug in equipment.
The EXP is available in two models:
EXP5 – features 5 x 10 Amp, 240V standard outlet sockets with a maximum total load of
10 Amps. This model plugs into a standard 10 Amp power socket so in most cases will not
require an electrician to install, and is suitable for many simple domestic systems.
EXP9 – features 9 x 10 Amp, 240V standard outlet sockets with a maximum total load of
20 Amps. The power lead on this model is fitted with an Industrial 3 (round) pin 20 Amp
plug, so installation may require an electrician to provide a suitable switched power outlet
socket.
In cases where control of higher power or 3 phase equipment is required, an electrician
may be required to install contactors to control this equipment.
16
To Next Page
Loading...
