poolstar POOLEX - Operation

EN | 15
EN
3. INSTALLATION
3.8 Operation
Use condions
For the heat pump to operate normally, the ambient air temperature must be between - 10 °C and
43 °C when it is used alone, or between - 20 °C and 10 °C when used with the SPA heater.
In order to be heated, the water must circulate in the heat pump. The heat pump will not start if
the water is not circulang.
Advance noce
Prior to starng the heat pump, please:
• Check that the equipment is in a stable posion.
• Check that your electrical installaon is in good working condion.
•
Check that the hydraulic connecons are properly ghtened and there is no water leakage.
• Remove any object that is not required around the equipment and all tools.
Operaon
1. Connect the power supply to the device.
2. Start the ltraon pump.
3. Acvate the device’s electrical supply protecon (dierenal switch situated on the
power cable).
4. Start the heat pump.
5. Select the desired temperature using one of the modes appearing on the control panel.
6. The heat pump’s compressor will start shortly aer.
7. Let the heat pump and the water pump run 24 hours a day unl the desired water tempe-
rature is reached. The heat pump will then stop working. The heat pump will then restart
automacally (as long as the water pump is running) as soon as the water temperature in
the pool is one degree lower than the set temperature.
WARNING: Under normal condions, a suitable heat pump can heat up the tub water by 1 °C
to 2°C per hour. It is therefore normal that you do not feel any dierence in temperature at the
outlet level when the heat pump is on.
Good to know: restart after power failure
Aer a power failure or a usual interrupon, turn the power back on. The system is in sleep
mode. Restart the dierenal plus and switch on the heat pump.
A heated tub must be covered and
insulated to avoid any heat loss.