Changing the hydraulic oil
The first oil change should be carried out after 500 operating hours, all further oil changes
should then be carried out after every 1000 operating hours or annually.
1 Oil inlet screw 3 Oil sight glass
2 Oil drain screw
▪ Retract the pusher before changing the oil.
▪ Remove the oil filling screw.
▪ Open the oil drain screw.
The oil drain screw is located on the base of the oil tank.
▪ Drain the old hydraulic oil into a container.
▪ Screw the oil drain screw back into the tank and fill with new hydraulic oil through the
filler screw opening.
▪ Screw the oil filling screw into the tank.
▪ Turn on the machine and allow it to run for a short while.
▪ Check the oil level and top up hydraulic oil if necessary.
Total filling capacity of the hydraulic system:
Quantity
60 litre
Please note that the information here concerns initial oil filling. Depending on the type
and variant, the refill quantity may be slightly less (as some of the hydraulic components
are not empty).
Our hydraulic system is filled with high-quality OMV ATF II transmission fluid.
▪ This oil has an extremely high viscosity index, exhibits excellent foaming and aging
characteristics and excellent flow properties at low temperatures and protects reliably
against wear and corrosion.
▪ Viscosity class ISO VG 46.
This high-quality oil comes highly recommended when changing the oil.
A mixture of products of the same quality poses no problem.
10.2.1
Maintenance
32
To Next Page
Loading...
Need help?
General
