[maximum stroke:] not assigned
[Trough angle:] Angle of the splitting trough
[Sensor height:] Distance of the "log diameter" laser sensor from the centre of the
splitting trough (displayed on the sensor)
See ........ Calibration function (in accordance with the table)
[Laser ø value) Displayed internal value (cannot be changed, is only displayed)
[Calibrate] The "log diameter" laser sensor is calibrated
See ........ Calibration function (in accordance with the table)
[Function:] Automatic: Knife adjustment and volume measurement
Measurement operation: volume measurement only (e.g. for
S-360)
[Nominal pressure:] not assigned
[Max. log length:] Maximum length of the sawn piece of wood
[Max. log diameter:] Maximum applicable log diameter
[Splitter S-400] not assigned
Calibration function:
▪ To set the sensor height, place the supplied angle plate (a solid sheet of paper) in the
splitting trough so that the laser beam hits the centre.
1
Splitting trough 2 Laser beam
Never stare into the laser beam.
For further information, please consult the supplied laser sensor user guide.
▪ Read the value off the laser sensor and enter in the [Sensor height] field.
▪ Using the arrow key [up / down], return to the [Calibrate] field and confirm with the [Enter
key].
Using the calibration function, any possible transmission discrepancy between the laser
sensor and control is offset.
▪ Using the arrow key [up], return to the [START] field (22) and return to the start menu
using the [Enter key].
Special equipment
51
To Next Page
Loading...
Need help?
General
