7.7.3 Fixed table of the rear seating group
The table-top of the fixed table of the rear seating group can be moved length-
ways.
Shift the table-top:
Undo the knurled screw (Fig. 39,6).
Move the table-top (Fig. 39,1) to the desired position.
Retighten the knurled screws.
Conversion to bed
foundation:
Undo the knurled screw (Fig. 39,2).
Lift off the table-top (Fig. 39,1).
Undo the knurled screw (Fig. 39,4).
Turn the table leg (Fig. 39,3) out of the base holder (Fig. 39,5).
Store the table leg and the table-top behind the driver's seat.
Pull out the slatted frames at the bench seats about 50 cm.
Place the cushions.
Fig. 39 Fixed table of the rear seating
group