Power Electronics SD700 Series Getting Started Manual

POWER ELECTRONICS
SD700 – TOUCH-GRAPHIC DISPLAY
SMS SERVICE
43
E
NGLISH
3.1.2. Special Messages
There are four predefined types of special messages: Help message, motor start, motor stop and
drive reset.
For each message type, the user should configure two attributes:
 Check box: User can use or not this message type depending on the selection.
 Label: The text the user should send through the SMS message in order to execute the
associated action.
The help messages provide the user with information about the ‘query messages’. Depending on
the format of the request, the user can obtain the following help information:
 ‘<HELP_LABEL>’: The graphic display returns to the user the list of available queries.
 ‘<HELP_LABEL> <QUERY_NAME>’ (separated by blank): The graphic display returns to
the user the help text that user defined for query when creating it.
 ‘<HELP_LABEL> <QUERY_NAME> <VARIABLE_ALIAS>’ (separated by blanks): The
graphic display returns to the user the help text that user defined for the variable when
creating the query.
When the user send messages to either start or stop the motor, or reset the drive, the graphic
display responds the user with a confirmation message and executes the corresponding action.
Otherwise, the graphic display responds to the user with an error message and the action will not
be executed.
For additional information about how to configure a special message, see section ‘3.3.5. Special
Messages Configuration’.
3.1.3. Notification Messages
There are three types of notification messages associated to the following events: motor started,
motor stopped and system fault.
For each message type, the user should configure two attributes:
 Check box: This type of event will generate a message or not according to the user
selection.
 Label: The text that the graphic display will send the user to notify such event.
This message type requires no action from the user. If one of the three previous events occurs,
the graphic display checks if the associated message has been activated by the user when
configuring the notification message. In this case, the graphic display searches all users with the
‘notification’ right and send to all of them the label associated to the event. If the event is a system
fault, the display will also add the fault description to the message.
For additional information about how to configure a notification message, see section ‘3.3.6.
Notification Messages Configuration’.

Power Electronics SD700 Series Specifications

General

Brand	Power Electronics
Model	SD700 Series
Category	Inverter
Language	English