Need help?Do you have a question about the Power Electronics ProfiPower SD700 Type 1 and is the answer not in the manual?
General| Operating Temperature | -20°C to +60°C |
|---|---|
| Mounting | DIN Rail |
| Input Voltage | 24 V DC |
| Output Voltage | 24 V DC |
| Efficiency | > 90% |
| Protection | Overvoltage, Overtemperature |
| Certifications | CE |
| Status Indicators | LED |
Guidelines for checking merchandise correspondence and reporting transport damage.
Procedure for separating and recycling drive packaging and electrical device parts.
Essential safety measures before operating the inverter, including reading the manual.
Description of the Profibus board for SD700, highlighting its connectors and status LEDs.
Details on the Profibus board kit contents, interfaces, and general information.
Explanation of the function of status LEDs (D308, D101) on the Profibus board.
Specifications for the Profibus-DP interface, including speed, data lengths, and GSD file.
Procedure for connecting the Profibus board to the SD700 drive using its connectors.
Description of board connectors (PROFIBUS, Earth) and status LEDs.
Wiring specifications for the Profibus SUB-D 9-pin connector according to EN 50170.
Setting drive control modes (Local, Remote, Serial Comms) via digital inputs.
Selection of the communication module (Modbus, Profibus, etc.) to be used by the drive.
Setting the Profibus slave address within the network using parameter G20.2.1.
Introduction to trial run phases: diagnosis, set up, and configuration.
How the master monitors slave status and uses diagnosis messages.
Details on setup messages containing configuration parameters for the Profibus board.
Description of Profibus modules (Type 1-5) with their I/O register configurations.
Explanation of diagnostic bytes and bit-encoded errors for configuration issues.
Interpreting scenario status using bit fields for read/write operations.
List of MODBUS error codes encountered during data exchange.
Procedure for installing the GSD file using SIMATIC administrator for Step 7.
Configuration for Profipower SD700 Type 1 module, defining up to 10 Scenarios.
Configuration for Profipower SD700 Type 2 module, defining up to 20 Scenarios.
Pre-defined registers for Type 3 module, receiving 10 bytes output, sending 4 bytes input.
Pre-defined registers for Type 4 module, receiving 54 bytes of output data.
Configuration for Profipower SD700 Type 5 module, defining up to 10 Scenarios.
Using SFC14 (DPRD_DAT) and SFC15 (DPWR_DAT) for data transmission and reception.
Using Step7 value tables for monitoring and modifying Modbus registers.
Examples of board diagnosis messages, such as Modbus communication timeout.
To Next Page