20
3 OPERATIONS continued
Interface Setting
Parameter 2: Set the charging current by pressing the
Down key or Up key.
For 1KVA model, there are four options, 2A, 3A, 4A and
5A. (Default: 5A)
For 2KVA model, there are six options, 2A, 3A, 4A, 5A, 6A,
8A and 10A (Default: 10A)
For 3KVA model, there are six options, 2A, 3A, 4A, 5A, 6A,
8A and 10A (Default: 10A)
08: Charging current setting
Interface Setting
Parameter 2: Enable or disable auto restart function.
You may choose the following two options.
ENA: auto restart enable(Default)
DIS: auto restart disable
09: Auto restart enable/disable
Interface Setting
Parameter 2: Set the minimum battery capacity by
pressing the Down key or Up key.
There are four options: 0%, 15%, 50%, 90% (Default: 0%)
15%: When 15% is selected, the UPS is discharged
until battery automatically shut down during power
failure. After the utility power is restored, the UPS will
automatically restart when battery capacity is greater
than 15% again.
10: Minimum battery capacity to restart UPS again
To Next Page
Loading...
