1 IMPORTANT SAFETY WARNING
Please comply with all warnings and operating instructions in this manual. Save this
manual properly and read carefully the following instructions before installing the unit.
Do not operate this unit before reading through all safety information and operating
instructions carefully.
Handling Safety
As the UPS can weight up to 22 kgs please lift correctly.
4
1-1. Transportation and Storage
• Please transport the UPS system only in the original packaging to protect against
shock and damage.
• The UPS must be stored in a facility where the temperature is well regulated.
Ambient temperatures should be between 0–40°C and relative humidity shall be
0–95% non-condensing.
1-2. Preparation
• Condensation may form if the UPS system is moved immediately from cold to warm
environment. The UPS system must be dry before being installed. Please allow
at least two hours for the UPS system to acclimatise to the environment prior to
energisation.
• If the UPS might be exposed to temperatures over 40°C, please contact PowerShield
for further advise.
• Do not install the UPS where the relative humidity exceeds 95%, and it must also be
non-condensing.
• Do not install the UPS near bodies of water or salt water (conformal coating may be
required to protect your UPS).
• Do not install the UPS in high dust, conductive dust environments (conformal coating
may be required to protect your UPS).
• Do not install the UPS system where it would be exposed to direct sunlight or nearby
heat source.
• Do not block ventilation holes on the UPS housing.
To Next Page
