powersoft K2 Series - Removing the Power Supply Board; Disconnect Fastons and Fan Cables; Remove Flat Cable Bridge

4
K2 – K3 Service Manual
Once the amplifier is open and its power supply fully
discharged, it is possible to start removing the single
boards.
3. REMOVING THE POWER SUPPLY BOARD
Disconnect the faston between the power supply board
and the output amplifier board :
Following this, unscrew the fans power cables close to
the previous faston.
Disconnect and remove the flat cable bridge between
the power supply board and output amplifier board:
Detail of connectors
Negative to this connector
Positive to this connector at first and then to this other one
Opened amp
Fastons between power supply board, output amplifier board and fan
power cables to be disconnected
Disconnected fastons between power supply board, output amplifier
board and fan power cables
Flat cable to be removed